[jmardy]

I hope I got a prototype
It might be OK for Ford pickup trucks with flat surfaces and no curves but it was impossible to get all but 4 pieces of the kit to work. The pieces that go on the outside of the headlights fit OK but even with those, one had a square cut at the bottom and the other side had an angled cut. The pieces that go on the inside of the headlights are mathematically impossible to fit.

Some pieces looked like they were cut by hand.
The piece that goes on the top of the rear bumper doesn't fit at all, maybe it's for a Cooper.

I'm uploading a picture of the piece that goes on the roof at the top of the windshield is typical of the installation.

Needless to say I am calling Invinca-shield tomorrow and asking for a refund. Hopefully they will get these problems sorted out before anyone else wastes an afternoon trying to make this stuff work.

Off to the pub for a pint now.
Cheers
-John