Hi, all.
I'm new here, so please tell me if this is not the correct forum for this post.
I've searched the various Mini2 forums but can't find the answers I need, so I'm hoping someone with experience of the Scangauge II might be able to offer some guidance/clarification on the following...
I just purchased a Scangauge II, and I can't get it to display any DTC info, despite the fact I've got 3 yellow warning lights.
Specifically, I have a March 2005, MCS (R53) on which ABS and DSC are currently non-operational. The following YELLOW warning lights are showing...
ABS
Tyre Pressure Sensor
Dynamic Stability Control
I imagine this might be caused by something like a faulty rotational sensor (or maybe steering angle sensor, or similar). The Scangauge websites mentions P,U,C & B codes, so I'd hoped this gizzmo would point me towards the actual fault. I thought this type of thing should be reported as a C code, but the unit simply says "No Codes Found"
I'm guessing the lack of DTC info might be because...
1) I need to do something other than press SCAN to get DTCs (maybe send a special command code?)
2) The unit is faulty (??)
3) Scangauge II does not support chassis codes for my R53 (in which case, I will be asking for a refund). Does anyone know for sure if codes would be reported for the warning lights I listed?
I'm not sure what I should do next. If anyone can offer any advice, I'd be extremely grateful. Thanks.
Regards
