Hi,
The rear seat bench just pulls up at each front corner, and un-hooks from the rear (behind the seat belf fasteners)
The back rests - (from inside the boot) in between the 2 seat backs is a clamp type thing?? securing the seats together -you will see 1 bolt head, undo this and push the lever up to release the middle of the seat back. Now tilt one of the seats about halfway down as if you were folding them flat and pull it out from the side panel, and repeat for the other. YOU SHOULD NOT NEED TO UNDO ANY TORX SCREWS
The rear trim panels just pull off when all the srews etc have been removed.
Put these instructions together with the FAQ and hopefull it will all make sense.
