Picked my seats up from Tony @ CoolNew on Saturday and went to fit them today ...
Firstly I need to get the correct tool for the job, while I could get the old seats out of the car no problem, I then found that I need a very short angled key in order to get the old seats of the old runners ... anyway will get one tomorrow and that should all be OK.
... anyway, put the seat back in and the forget the reconnect the airbag sensors at which point I noticed the light on the dash was on ! Ignition off and plugged connections back in. Ignition on ... A/B light stays on.
Questions ;
Because it picked up a problem with the A/B once will the light stay on until the dealer checks/resets the computer ? (just a thought)
Once the
JCW seats are in is it a dealer job to disable the sensors so that the airbag light is not one 100% of the time or is there anyway of doing this myself ?
Many thanks