bonnet catch problem and more.
The wifes mini's bonnet hasn't been catching properly on the passenger side, so yesterday i fitted a second hand catch i got off ebay, but to no avail as we still have the same problem.
So next i check the cables which seem fine as they both move slightly at the bonnet catch ends when you pull the interior release lever!
To make matters worse, when i was messing with the cables i took off the panel around the release pull inside the car and seem to have dislodged a wiring connector block of some kind! so can anybody tell me where this connector block should go or could it be for a optional extra for a different model that uses the same wiring loom? Therefore maybe it's not needed in our car?
The cars a Mini Cooper R50 '01 model
The car starts and runs fine, however i havn't drove it anywhere since.
If anyone can help with the above two problems i would be very grateful.
Thanks in advance Olly
Last edited by ollygunner; Aug 27th, 2013 at 12:58 PM.