Fitting clear side repeators - Help!

[vigilante]

Hi Guys and Gals...

apologies if this has already been covered (i can't find it)....

Does anyone have a "how to..." or at least could fill me in on how to change my monstrous amber side repeaters for the spanky new clear ones i have just purchased...

I have the parts, I have the bulbs....I just need a clue

any help would be much appreciated...
Thanks for listening peeps!

[laura f]

I thought it was just a straight swop

reach down, graze hand, replace bulb....

[MINIMAT]

Do you have just the indicator cover or a shark gill? For just the indicator cover I got a screwdriver in at the front of the old cover and with a little leverage it popped out. Then turn the L shaped assembly behind through about 30 degrees while holding onto the indicator cover and it will come off.

[MartinSSZ]

Instructions and pics here on my web site here: http://martinlewis.co.uk/ml/mini-side-repeater-change/

[MINIMAT]

One thing I noticed. To avoid a 'fried egg' look I got silvered indicators. Then I found they didn't look as bright as I'd like so I swapped the clear indicators for jewel indicators.

[vigilante]

thanx guys...the are the ultra jewel indicators - no gills - i'll do it after stuffin my facce on chips

cheers peeps

[Electric Blue]

If you get stuck gimme a shout mate and I'll give you some bad help,

[GameStone]

You don't have to take out the side repeater grill as the instructions say, just push the repeater lens in one direction and it will come out, change the bulb by rotateing the back (only goes one way).

[MartinSSZ]

True

[tyrerc]

small screw driver is the only tool needed, as above just ease it out and change, 2 min job

[vigilante]

thanx again guys...karl, i'll try tomorrow lunch in daylight and shout you if i break anything...

[vigilante]

All fitted

ahh...much better...