MINI Cooper Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. MINI Faults & Fixes
    Hello, I just had my Mini R56 diagnosed and the picture below is what came back. could anybody help with what it all means? The electoral bits I ain’t fussed about it’s more the Top Two issues!
  2. Second Generation Faults & Fixes
    Hi guys, if you do not own a Diagnostics scanner that can do a Vanos reset/relearn after a timing chain replacement, will it automatically relearn over time? The one I have does show the degrees requested for each cam shaft and the actual, and they virtually match at different rpm, does that...
  3. MINI Faults & Fixes
    Hi All, first time poster :) Just finished head gasket replacement on Mini 2010 Cooper S (N18). Replaced all gaskets, washers, chains etc. as I've completed the work and followed BMW's technical instructions. Started the car and it threw a 002D60 code - VANOS, exhaust: control fault, camshaft...
  4. Maintenance & MINI Care
    My 2007 Mini cooper R56 has got a P0013 code with amber engine warning light and an eratic idle RPM (this settles down after the car has warmed up but the fault code remains). After a bit of searching about i've seen that it is likely something to do with the VANOS system. I have had a look...
  5. General Discussion
    If anyone can help that would be great, on cold start I get a short rattle that I believe to be the camshaft not getting the required oil. I've had the chain replaced so it cannot be that, only thing I can think of is VANOS solenoid seal gone bad. I've just ordered a new solenoid as they're...
  6. Second Generation MINI Tuning
    During past winter my 2008 clubman started throwing P0015 errors, sometimes with careful acceleration the error would go away only to come back again later. Once it even went into limp-home mode, but after resetting the errors via Torque and a bluetooth dongle and waiting for it to warm up after...
  7. Second Generation MINI Cooper
    I have been trying to get my 2009 cooper project to run properly for a couple weeks. Upon first start the idle is lumpy but eventually smooths out. The vanos position and eccentric shaft position move around with revs and load as they should. Actual and commanded values are within 1 degree. The...
  8. MINI Faults & Fixes
    advice would much be appreciated! Thanks
1-8 of 8 Results
Top