MINI Cooper Forum banner

Mini fault codes P0342 and P0341

7K views 5 replies 5 participants last post by  mike1967 
#1 ·
Hope this is in the right section, had 2 fault codes on my 09 Mini Cooper above P0342 which is ‘camshaft position sensor A cct low bank 1 or single sensor’
And P0341 camshaft position and ideas how I can fix these which sensor I need to change as the engine idles rough, Stalls a lot when you start moving any help appreciated.
duncan
 
#3 ·
likely the top guide has snapped off timing chain common issues would not run the car needs looking at asap
 
#5 ·
Do you still rebuild Mini Cooper S engines? If so what is the cost and where are you located? I just had mine replaced with a used one ( runs great minus the error codes) but I am looking into the near future. No one in my area will rebuild them and crate motors are way too expensive. Switching to a 350 Chevy would probably be cheaper. Lol jk I would use an LS .
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top