MINI Cooper Forum banner
1 - 1 of 4 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi All,

I'm trying to fit cruise control into my wife's R56 One.

It has the 2-spoke steering wheel so I've replaced it with the MFSW 3-spoke and the slip ring (61319253767).

I spent some time trawling through RealOEM to get the correct slip ring for the car, no Xenon, no auto wipers, has DSC and ended up with the part number above which I believe to be correct.

All parts fitted and no DSC issues to report after clearing the fault codes in INPA.

I have the latest BMW Standard Tools 2.12 installed but I get repeated errors when trying to read the SZL module as shown in attached image.

As you can see the $249 has stuck in the VO/FA (orange underline in the image).

I have done the FAWrite to the CAS and FRM modules with success and performed an SGReset on all modules with the exception of the SZL as it gives errors.

Please can you advise on where I'm going wrong as I'd love to get the cruise control up and running.

I'm no master when it comes to NCS, I've only been on it for a few days and read all of the thread and guides I possibly could to help to no avail.

All help is truly appreciated


1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.